1. Home
  2. Knowledge Base
  3. BAT-Connect
  4. BAT-Connect Honeywell Vista install step guide

PRE-INSTALL

  • Have these tools on hand: Screwdriver, Wire Stripper, Cordless Drill, Level

ACCOUNT SET-UP

  • Visit AlulaConnect.com
  • Sign in with your Access Code, Username and Password
  • Click “Add Customer Account”
  • Type user’s name and password for the app
  • Click on Account Devices in the menu
  • Click the “Add Hardware” button
  • Type in the MAC and CRC number

PRO-TIP: The MAC and CRC number are found inside the cover of the BAT-Connect.

  • Click on the device serial number
  • Input customer info for your records
  • Type in panel’s Central Station Account Number
  • Add customer phone number for Caller ID
  • Add device location

PRO-TIP: You will see “device appears to be offline” notification until BAT-Connect is installed and activated

  • Add the Master Code to the account

PRO-TIP: Disarm all partitions of the system if they aren’t already. Disarm via Honeywell Keypad

PREPARE THE VISTA PANEL

  • Enter panel programming mode using the installer code (show panel programming)
  • Configure the panel 
  • Exit programming mode
  • Disconnect the Vista battery
  • Unplug the transformer

PRO-TIP: For Vista 21IP panels, the Internal IP/GSM jumper needs to be set to “Off.”

MOUNT BAT-CONNECT TO WALL

  • Place near security panel
  • Mark the holes for drilling
  • Drill in mounting screw

PRO-TIP Be careful not to overtighten the center screw, which is a wall tamper

BAT WIRING

  • Connect black wire to BAT-Connect GND
  • Connect red wire to BAT-Connect 12V
  • Connect green wire to BAT-Connect G IN
  • Connect yellow wire to BAT-Connect Y IN

VISTA WIRING

  • Connect black wire to terminal 4 (negative)
  • Connect red wire to terminal 5 (positive)
  • Connect green wire to terminal 6 (data in)
  • Connect yellow wire to terminal 7 (data out)

 

POWER UP VISTA

  • Reconnect the Vista battery
  • Plug in transformer

PRO-TIP: The Vista system will be busy for 50-60 seconds before BAT-Connect automatically programs it. Honeywell keypad will show System Busy and the Version of the panel

  • Keypad will display “DISARMED Ready to Arm”
  • Confirm cellular LED and verify signal strength

PRO-TIP: A minimum of two signal bar LEDs in recommended

  • Plug in Ethernet
  • Confirm Ethernet LED in on

WI-FI

  • Enable WPS on router 
  • Press and hold WPS button
  • Wait for Wi-Fi LED flashes 

PRO-TIP: If the Wi-Fi LED turns off after 3 minutes, then WPS was not successful.

  • Unplug the ethernet cable
  • After 1-2 minutes, the Wi-Fi LED will turn on

PRO-TIP: If WPS in unavailable, Wi-Fi credentials can be entered in AlulaConnect

  • Reconnect Ethernet cable 
  • Close BAT-Connect cover 
  • Open the Alula app on your phone
  • Arm and Disarm to confirm system is operational
  • Check event log on AlulaConnect to verify Central Station received signals

Related Articles